The traditional process of squeezing camellia seeds is to use a hydraulic oil press. The hydraulic oil press needs to pack cakes and steam to press camellia seeds, and the process is very cumbersome. Now, the screw press can replace the hydraulic press used in camellia seeds.
So what are the advantages of the screw press for squeezing camellia seeds? The screw oil press for squeezing camellia seeds cannot use ordinary snails from snails, peanuts, and sunflowers. The lignin content of camellia seeds is relatively high, and special snails are needed to squeeze the camellia seeds.
Advantages of screw oil press for pressing camellia seeds
1.Advanced technology and long life.
The screw oil press uses steel, which has been carburized and quenched or high-frequency quenched. It has high hardness, good wear resistance, high density, and balanced operation without noise. Satisfy long-term continuous automatic production.
2.High oil output rate, large output and high pressure in the press chamber.
The pressure of the special screw press is higher, the output is also greatly improved, the design of the press chamber and the screw press is more scientific and reasonable, and the pressing process is more perfect. In terms of pressing methods, there are raw pressing, hot pressing (cooked pressing) and so on.
People can use different squeezing methods according to different eating habits in different regions.
1.Raw pressing (cold pressing): Put the oil directly into the oil press to start normal production.
2.Hot pressing (cooked pressing): After the oil is fried, it is directly put into the oil press to press it normally, and it is squeezed again.
3.Low energy consumption and labor saving: The screw oil press squeezes out tile-shaped pancakes. The residual oil rate of the pancakes is low. The oil output rate is high. Infrared heating is used. Automatic temperature control reduces heat energy loss and shortens heating time. The gearbox adopts planetary gears, which greatly reduces energy consumption by more than 30%. Electric automatic control production, fewer employees (1-2 people).
