Many customers ignore to run in and warm up the equipment before starting the oil press. This process of running in and heating up makes the temperature in the press chamber have a great influence on the pressing effect and oil yield of the oil press. The normal pressure cannot be formed in the pressing chamber, and the cake cannot be formed, which affects the oil output effect.cold oil press for sale
Many new customers tend to ignore the process of running in and heating up. The operation methods are as follows:
1. Mix the crushed dry cake with 10% hot water and press repeatedly (except for the tea seed cake).extract plant oils pressing
2.Start feeding slowly and evenly (remember: the feeding should not be too violent, and the material should not be too dry). And observe whether the cake is out of the cake. In the gap between the cakes, the feeding amount can be gradually increased after the cakes are normal. And it is observed whether the cakes and feeding are normal.edible oil press
3.During repeated pressing, the moisture in the dry cake gradually decreases. So it is necessary to observe and check at any time and increase the moisture appropriately.press machines for sale
4.In the stage of running in and heating up, the oil press is most likely to cause the screw shaft to be stuck due to improper operation. And cause failures such as damage to the press bar.vegetable oil expeller
Therefore, users are specially reminded that the moisture in the dry cake used for running-in must not be too little. And should be checked at any time, and the moisture should be kept at about 10% to avoid the occurrence of jamming.industrial cold press machine
Under normal circumstances, the temperature of the machine gradually increases from the feed end to the cake discharge end. Until the temperature outside the press at the feed end feels hot, and then the pressing can be started.oil machine